Effect of dislocation structure on fracture toughness of strained BCC-metals

Mechanical properties of materials depend on their structure. Examined are the effects of dislocation structure on fracture toughness and mechanisms of fracture of BCC-metals. Fracture toughness was determined by depending specimens with cracks introduced into the plane perpendicular to the plane of rolling. Fracture toughness increases with decreasing yield stress (for =15–25%). This is due to instability of slightly misoriented cell structure under repeated loading. The peak of fracture toughness at the temperature 77 K was not observed. The increase of fracture toughness for high strained metals (>60% for Mo, and >85% for Cr) corresponds to cell size reduction and the change of fracture mechanisms.     

一类平面自治非线性时滞控制系统的多稳态和混沌

众所周知，平面自治系统即使具有光滑非线性存在，系统也不会出现复杂的动力学行为。本文研究这样的系统存在时滞时，时滞量对系统的动力学行为的影响。通过对一个平面自治非线性系统引入时滞反馈，得到数学模型。利用泛函分析和平均法建立系统平衡态随时滞量变化的失稳机理，研究表明：时滞量平面自治系统动力学行为的影响是本质的．时滞量不但可以使系统出现Hopf分岔，产生周期振动。而且还可以使系统出现多稳态的周期运动或周期吸引子，这些共存的吸引子相碰是导致系统复杂的动力学行为，包括概周期和混沌运动。     

Two-dimensional stability problem for two interacting short fibers in a composite: In-line arrangement

A solution is found to a plane problem for a composite material reinforced with two in-line fibers and subjected to longitudinal compression. The problem formulation is based on the piecewise-homogeneous model and the three-dimensional theory of stability. The dependence of the critical strain and buckling mode on the distance between the fibers is studied for various mechanical and geometrical characteristics of the composite components.Translated from Prikladnaya Mekhanika, Vol. 40, No. 9, pp. 65–74, September 2004.     

Natural oscillations of a jet membrane under hydrostatic pressure

The natural oscillations of a submerged elastic jet membrane modeling an axisymmetric hydrodynamic direct-flow radiator are analyzed. The fundamental frequency is calculated as a function of the geometric and hydrodynamic characteristics of the jet. The principle possibility of adjusting the frequency by changing the elasticity of the fluid, which is a function of hydrostatic pressure, is demonstrated. Numerical and experimental data are compared.__________Translated from Prikladnaya Mekhanika, Vol. 40, No. 12, pp. 92–98, December 2004.     

Effect of Free‐Stream Turbulence on the Flow Structure near a Wedge and the Windward Side of an Airfoil

The flow structure behind wire grids is studied for flows with a low subsonic velocity, and the effect of grids on the boundarylayer flow structure is considered. It is shown that the meanvelocity inhomogeneity induced by the grid does not disappear until a distance of 925 calibers downstream of the grid is reached. Liquidcrystal thermography combined with hotwire measurements made it possible to find the source of steady largescale streamwise vortex structures in the boundary layer on a wedge and on an airfoil and to determine the parameters of these structures.     

Asymptotics for eigenvalues of the Laplacian with a Neumann boundary condition on a thin cut-out tubeComportement asymptotique des valeurs propres du laplacien avec conditions de Neumann sur un tube extrait

We consider the eigenvalue problem for the Laplace operator in a bounded three-dimensional domain where a thin tube is cut out. Imposing a Neumann boundary condition on the boundary of this tube, we construct asymptotics for eigenvalues on the small parameter that is a diameter of the tube. To cite this article: M.Yu. Planida, C. R. Mecanique 331 (2003).     

稀土处理玻璃纤维填充聚四氟乙烯复合材料在油润滑下的摩擦学性能

分别用偶联剂、稀土以及偶联剂 -稀土混合物处理玻璃纤维表面 ,以改善玻璃纤维与聚四氟乙烯之间的界面结合力 ,考察了玻璃纤维填充聚四氟乙烯复合材料在油润滑下的摩擦学性能 .结果表明 :在油润滑条件下 ,表面处理玻璃纤维填充聚四氟乙烯复合材料的摩擦系数比未经处理玻璃纤维填充聚四氟乙烯复合材料的低 ,耐磨性亦较优 ;而稀土处理玻璃纤维填充聚四氟乙烯复合材料具有最低的摩擦系数及最高的耐磨性和极限 pv值 ;未经处理玻璃纤维填充聚四氟乙烯复合材料的磨损形式主要为粘着转移 ,偶联剂处理玻璃纤维填充聚四氟乙烯复合材料和偶联剂与稀土处理玻璃纤维填充聚四氟乙烯复合材料均以磨粒磨损为主 ,而稀土处理玻璃纤维填充聚四氟乙烯复合材料的磨损机理主要为粘着磨损和轻微磨粒磨损     

Invertibility conditions for the nonlinear difference operator (\mathcal{D}x)(n) = x(n + 1) - f(x(n)) in the space l ∞(ℤ, ℝ)

We obtain necessary and sufficient conditions for the invertibility of the nonlinear difference operator $(\mathcal{D}x)(n) = x(n + 1) - f(x(n))$ , n ∈ ?, in the space of bounded two-sided number sequences. Here, f: ? → ? is a continuous function.     

昆虫拍翼方式的非定常流动物理再探讨

基于提出的理论模化方法来探讨昆虫拍翼方式的非定常流动物理. 以悬停飞行为 例，通过对拍翼运动的分析，不仅解释了昆虫利用高频拍翼的方式为何能够克服低雷诺数带 来的气动局限性(St \gg 1/Re)，而且还指出高升力产生和调节的3个流动 控制因素：(1) 由于拍翼的变速运动即时引起了流体动力响应，这种附加惯性效应 可产生瞬时的高升力; (2) 保持前缘涡不脱离翼面有助于减少升力的下降; (3) 增大后缘涡的强度并加速其脱离后缘能够有效地提高升力.     

体积分数对基于沸石和硅油的悬浮液的电流变性能的影响

用 HAAKE RV2 0型流变仪 ,在不同外加电场强度和不同颗粒体积分数下测试了基于沸石和硅油的电流变液的剪切应力变化 .结果表明 :随着外加电场强度升高 ,电流变液的零电场粘度急剧增加 ,电流变液的剪切屈服应力增加 ;随着电流变液中沸石颗粒体积分数升高 ,电流变液的剪切屈服强度急剧上升 .这种变化可以用颗粒间作用力与颗粒间距的关系、单位面积的颗粒链数目变化以及多体作用对电流变液性能的影响来解释